Page 15
| Fathom
ICS
IN-CEILING INSTALLATION
Type: IC-1
Test Fit Enclosure
With the assistance of a helper, lift
the enclosure into the ceiling cavity,
positioning the Stud Mounts (Parts
B & C) above the ends of the Joist
Mounting Brackets (Parts E & F) and
slide the enclosure inward until the
Stud Mounts (Parts B & C) contact the
Joist Mounting Brackets (Parts E & F).
To prevent the enclosure from falling
out, ensure that the exposed dowel
pins at the ends of the Stud Mounts
(Parts B & C) are located on the
outside of the Joist Mounting Brackets
(Parts E & F).
(Figure 4)
Set the Enclosure’s Final Position
Adjust the enclosure’s position
to the middle of the ceiling cavity.
Centering the enclosure within the
ceiling cavity, so that no sides of the
enclosure are in contact with the
joists, will reduce the potential for
unwanted noise and vibration.
Install two #8 x 2.00-inch pan
head screws through the guide holes
located at each end of the Stud Mounts
(Parts B & C) to set the enclosure’s
final position. Select the guide hole
locations that will place each screw at
or near the center of each joist.
(Figure 5)
Note: As this is the last
opportunity before permanently
mounting the enclosure, we highly
recommend to double-check
that the position of the driver/
grille (Wallboard Template -
Part A) is at the desired location
within the floor plan.
Figure 4
Figure 5
Summary of Contents for FATHOM ICS-SYS-108
