Page 31
| Fathom
ICS
FOAM GASKET
INSTALLATION
The included energy absorbing
adhesive foam gasket strip is
used to reduce the potential for
noise and vibration between the
joists/studs and wallboard.
Remove the backing and firmly
press the foam gasket strip to all joist/
stud faces surrounding the enclosure.
Use a utility knife or scissors to cut
and trim the edges of the foam gasket
strip.
(Figure 27)
Install the Wallboard
Install the surrounding wallboard
using the Wallboard Template (Part
A) as a hard edge. The surrounding
wallboard should be installed flush
against the edge of the wallboard
template on all four sides.
Note: It is critical that any gaps
between the wallboard template and
surrounding wallboard do not exceed
1/8-inch. Use joint compound to fill
any spaces greater than 1/8-inch.
Once installed, the surrounding
wallboard should be painted.
Figure 27
Summary of Contents for FATHOM ICS-SYS-108
