Page 27
| Fathom
ICS
IN-WALL INSTALLATION
Type: IW-1
Attach the Floor Support (Part D)
To simplify installation, the
enclosure is shipped with the
following parts pre-attached:
Part A – Wallboard Template
Part B – Upper Stud Mount
Part C – Lower Stud Mount
Part D – Floor Support
(shrink
wrapped to enclosure)
Place the enclosure on a supported
surface/table and remove the shrink
wrap from the Floor Support (Part D).
Position the Floor Support
(Part D) in the recessed area of the
Wallboard Template (Part A) and
Lower Stud Mount (Part C). Using the
predrilled pilot holes as guides, install
four #8 x 1.25-inch wafer head screws
to attach the Floor Support (Part D)
to the Wallboard Template (Part A)
(Figure 22)
Figure 22
Summary of Contents for FATHOM ICS-SYS-108
