| Fathom
ICS
Page 20
IN-CEILING INSTALLATION
Type: IC-2
Attach the Extended Stud Mounts
The pre-attached Stud Mounts
(Parts B & C) will not be used in this
application. Place the enclosure on a
supported surface/table and remove
the Stud Mounts (Parts B & C) for
recycling (retain the #8 x 1.25-inch
wafer head screws).
Position the Extended Stud Mounts
(Parts G & H) on the enclosure, with
the inscribed center marks aligned with
the vertical center of the enclosure.
Attach the the Extended Stud Mounts
(Parts G & H) to the enclosure using
the wafer head screws that were
removed earlier. Make sure to install
the wafer head screws into the same
mounting holes of the enclosure that
were used for the pre-attached Stud
Mounts (Parts B & C) removed earlier.
(Figure 11)
Note: The enclosure is equipped
with engraved arrows that point to
the approved mounting locations
(pre-drilled holes) for attaching
the Stud Mounts to the enclosure.
Installing fasteners at any other
locations is not recommended and
may create air leaks in the enclosure.
Figure 11
Arrows point to pre-drilled
attachment holes locations.
Align the inscribed
center position marks
with the vertical center
of the enclosure.
Summary of Contents for FATHOM ICS-SYS-108
