JL Audio FATHOM ICS-SYS-108, Installation Manual, Page: 29 / 36

Page 29 | Fathom ICS
IN-WALL INSTALLATION
Type: IW-1
Mounting the Enclosure
Place an L-Bracket (Part J) at one of
the corner ends of the enclosure, with
its slotted openings positioned over the
pilot holes. Select two, non-adjacent
pilot holes within each slotted opening
(one to two holes apart) and fully
install two #8 x 1.00-inch pan head
screws. Then, partially back out each
screw, leaving just one to two threads
exposed beneath each screw head.
The L-Bracket should remain loose,
allowing it to slide for adjustment
during installation.
(Figure 24)
Slide the L-Bracket (Part J) outward
and secure to the stud using six #8 x
1.25-inch wafer head screws. Repeat
this procedure with the remaining
L-Brackets (Part J) at the remaining
corner ends of the enclosure. Next,
fully tighten all screws previously
installed in the slotted openings and
lock the position of all L-Brackets
(Part J) by installing a #8 x 1.00-inch
pan head screw into one of the two
holes located in between the slotted
openings.
(Figure 25)
Uninstall all screws from both
Stud Mounts (Parts B & C) and
remove for recycling. Uninstall the all
screws from the Floor Support (Part
D) and remove for recycling.
PROCEED TO ROUTING THE
SPEAKER CABLE (page 30)
Figure 24
Figure 25
1
3 2
PRO-TIP:
You may find it easier to install the
L-Brackets (Part J) at the bottom end
of the enclosure using a right-angle
drill/driver.