JL Audio FATHOM ICS-SYS-108, Installation Manual, Page: 13 / 36

Page 13 | Fathom ICS
Figure 2
Arrows indicate pre-drilled
attachment holes
Represents the horizontal
center line of driver/grille.
Not used with in-ceiling installations.
(Remove and recycle.)
Figure 1
Remove the Floor Support (Part D)
To simplify installation, the
enclosure is shipped with the
following parts pre-attached:
Part A – Wallboard Template
Part B – Upper Stud Mount
Part C – Lower Stud Mount
Part D – Floor Support
(shrink
wrapped to enclosure)
For in-ceiling installations, the
Floor Support (Part D) will not
be used. Place the enclosure on a
supported surface/table and remove
the shrink wrap to detach the Floor
Support (Part D).
(Figure 1)
Stud Mount Attachment Points
The enclosure is equipped with
engraved arrows that point to the
approved mounting locations (pre-
drilled holes) for attaching the
Stud Mounts (Parts B & C) or the
Extended Stud Mounts (Parts G &
H) to the enclosure.
Note: Installing
fasteners at any other locations is not
recommended and may create air
leaks in the enclosure.
(Figure 2)
Driver/Grille Center Line
The dashed line at left represents
the horizontal center line of the
wallboard template after the enclosure
is installed. This may be used for
referencing the placement of the
driver/grille at its final position within
the desired floor plan.
(Figure 2)