| Fathom
ICS
Page 32
GRILLE INSTALLATION
PROCEDURE
Before you Begin
The following instructions
assume the ICS Enclosure has
already been installed.
The Grille Assembly
The grille assembly is comprised
of a removable outer metal mesh and
grille tray. The grille assembly should
be installed only after the surrounding
wallboard and grille assembly have
been painted and the room’s interior
is free of construction debris. A plastic
paint guard is included to shield the
inner black section of the grille tray
from overspray during painting.
The grille tray and outer metal mesh
grille should be painted separately to
prevent them from sticking together.
Two sets of different length thumb
screws are included with the grille
assembly to fit a range of wallboard
thicknesses. It is critical to use the
correct thumb screw length for a
proper fit. Refer to the table at right
to select the thumb screw length that
is compatible with the wallboard
thickness used in your application.
Wallboard Template Removal
To remove the Wallboard Template
(Part A), uninstall the four 1/4 – 20 x
1.25-inch, T27 machine screws and lift
it away from the enclosure.
(Figure 1)
Figure 1
PRO-TIP:
Y
ou may find it easier to partially
screw two screws into the center area
of the template to use as a grip as you
pull away.
Thumb Screw Length
Wallboard Thickness
1.75”
2.5”
1/4-20 x 1.75 in.
1/2 in. to less than 1-1/16 in.
13 mm to less than 27 mm
1.75”
2.5”
1/4-20 x 2.5 in.
1-1/16 in. to less than 1-3/4 in.
27 mm to less than 44 mm
Grille Assembly
1
Outer Metal Mesh
2
Grille Tray
3
Rubber Stoppers
4
Thumb Screws
2
3
4
1
Summary of Contents for FATHOM ICS-SYS-108
