![background image](http://html.mh-extra.com/html/sonance/bps6-tl/bps6-tl_quick-start-manual_1319837001.webp)
Determine the location of the mounting platform
and subwoofer. Ensure there is adequate space to
accommodate the subwoofer and port tube within the
2 x 4 stud bay or joist, allowing 15” from the front edge
of the BPS6 TL to the center of connector. (See Figure 1).
Box Contents
(1) Quickstart Guide
(1) Bandpass Subwoofer with port tube
(1) Cardboard mounting template
MOUNTING SCREWS & WASHERS:
(4) 5/16” x 3” lag screws
(4) 5/16” washers
BPS6 TL QUICKSTART GUIDE FOR USE WITH
ARCHITECTURAL SERIES BANDPASS CONNECTORS
BANDPASS SUBWOOFER THINLINE (AS)
Place the subwoofer mounting template on the side of a
2 x 4 stud or joist and drill four 1/4” (6mm) holes through
the stud at the locations shown on the mounting template.
(See Figure 2).
Hold the side of the BPS6 TL Subwoofer with the rubber
damping pad up against the side of the stud or joist and
install the four lag screws and washers to secure the
BPS6 TL Subwoofer in place. (See Figure 3).
1
15” (381mm)
BPS6 TL
Architectural Series
mounting platform
Port Tube
NOTE: IF IT IS NOT POSSIBLE TO LOCATE THE BPS6 TL SUBWOOFER
15” AWAY FROM THE 90 DEGREE CONNECTOR OF THE MOUNTING
PLATFORM, EXTRA HOSE MATERIAL (UP TO 3”) MAY BE REMOVED.
WHILE IT IS OKAY TO SHORTEN THE HOSE, NEVER EXTEND THE
HOSE LENGTH.
NOTE: DRILLING FROM THE INSIDE OF THE STUD BAY IS
RECOMMENDED TO ENSURE THAT THE HOLE LOCATIONS
MATCH THE SUBWOOFER SCREW LOCATIONS. (SEE FIGURE 2)
NOTE: BE SURE THAT THE SUBWOOFER TEMPLATE IS FLUSH
WITH THE EDGE OF THE STUD OR SLIGHTLY RECESSED.
Prepare to attach the mounting platform to the stud
or joist. Position the platform with the 90 degree
connector pointed in the direction of the BPS6 TL
port tube. (See Figure 4).
2
3
4
Figure 1
Figure 2
Figure 3
Figure 4
Template