![background image](http://html1.mh-extra.com/html/jcm-global/vega-series/vega-series_operation-and-maintenance-manual_3554016053.webp)
P/N 960-100189R_Rev. 4 {EDP #148850}
© 2016, JAPAN CASH MACHINE CO., LTD.
6 - 1
S e c t i o n 6
This section provides Calibration and Performance
Testing instruction for the VEGA Banknote
Validator. This section contains the following
information:
•
Tool Requirements
•
Installation Procedures
•
Calibration
•
Performance Test
Tool Requirements
Figure 6-1 illustrates and list identifies the tools
and equipment interconnects necessary to down-
load and install the VEGA.
Installation Procedures
Perform the following steps to install the various
VEGA Software Drivers (Refer to Figure 6-1 and
Figure 6-2 for the necessary Tool and Harness
Connections and USB Cable Requirements).
Before downloading the VEGA Software package,
the VEGA USB Driver must be installed in a des-
ignated Folder on the PC first as follows:
1. Create a VEGA Folder on the “C” Drive (e.g.,
C:\VEGA), and copy the VEGA USB Drivers
“
usbser.sys
” and “
usbvega.inf
” into the PC
Folder created.
2. Connect the USB Cable to the VEGA Unit.
3. Supply power to the VEGA Unit.
4. The
“
Found New Hardware Wizard
” Screen
shown in Figure 6-4 appears. Click on the Radio
Button
located beside “No, not this time”
a
), and then Click on the “
Next>
”
Button (Figure 6-3
b
).
5. On the next screen that appears, click on the
Radio Button
located next to “
Install from a
list or specific location (Advanced)
6 CALIBRATION AND TESTING
Figure 6-1
c
d
d
2
b
f
a
Interface
Connector
Power Supply
To AC
VEGA USB
Connector
To PC USB Port
Power
e
a) VEGA Unit
b) Power Supply
(following Electrical Specification)
c) PC
(OS: Windows XP/7/8)(VEGA Driver Installed)
d) USB Cable
d
1
) USB A Terminal
d
2
) USB Mini-B Terminal
e) Application Software
f) Harness
Figure 6-1
Tool and Harness Connection
NOTE: Be sure to use the correct input
voltage for each Product Specification.
WARNING: Ensure that the VEGA Unit’s
power is OFF before connecting
harnesses. Connecting harnesses
while the power is ON may damage the
VEGA or cause electrical shock.
Figure 6-2
Figure 6-2
Tool and Harness Connection
b
a) PC Side (USB A Terminal)
b) VEGA Side (USB Mini-B Terminal)
Figure 6-3
a
b
Figure 6-3
Hardware Wizard Welcome Screen