P/N 960-100189R_Rev. 4 {EDP #148850}
© 2016, JAPAN CASH MACHINE CO., LTD.
2 - 3
Installation
VEGA™ Series Banknote Validator
Section 2
DIP Switch Block #3 selects between RS232C and
Pulse Mode Communication (Table 2-3).
Special Settings
When the VEGA Status LED indicates Stand-by
operation, set the desired LED Indication Pattern or
rewrite the ccTalk Initialization Encryption Code
by performing the special setting information that
follows.
LED Pattern Setting Mode
To change the LED Indication Pattern to show a
Green
,
Blue
or Rainbow Gradient Color, set the
DIP Switches as indicated in Table 2-4 for the
desired LED result.
To set and save the desired LED setting proceed as
follows:
1. Turn the VEGA Unit Power
OFF
.
2. Set DS1 Switches #1, #2 and #7 to
ON
when
choosing the LED gradient indication.
3. Turn the VEGA Unit Power
ON
.
4. Set DS1 Switch #1 to
OFF
to memorize the
Stand-by setting indication and embed it into the
VEGA Unit memory.
5. The selected color setting will be reflected by the
Front Panel LED Color flashing indication when
the desired assignment is completed correctly.
Rewriting ccTalk Encryption Code
(Initialize)
The ccTalk Interface Encryption Code is rewritten
with the VEGA Serial Number by setting DIP
Switch Block #1 as shown in Figure 2-6, and per-
forming the following Encryption Code Initializa-
tion Instructions.
To set and save the Serial Number as the default
ccTalk Encryption Code, proceed as follows:
1. Turn the VEGA Unit Power
OFF
.
2. Set DIP Switch Block DS1 Switches #1 through
#6 to ON.
3. Turn the VEGA Unit Power
ON
.
4. Set DS1 Switch #1 to
OFF
.
When the LED is extinguished, Encryption Code
rewriting into the Serial Number (Initialize) has
begun.
5. The LED will flash
Blue
when the memory
rewrite procedure is complete.
Table 2-2
DIP Switch Block 2 Settings
Switch No.
Switch ON
Switch OFF
1
Refer to the Related Country’s Software
Specification Sheet
2
3
4
5
6
7
8
Table 2-3
DIP Switch Block 3 Settings
Switch No.
Switch ON
Switch OFF
1
RS232C Interface
Pulse Interface
Table 2-4
DIP Switch DS1 Color Settings
Color
DIP Switch DS1
Rainbow Gradient
Blue
Green
DS2
6
7
8
IF Setting
OFF
OFF
OFF
ID-003 (RS-232C)
OFF
ON
ON
ID-003
(Photo-Coupler Isolation)
OFF
ON
OFF
ccTalk (No Encryption)
ON
ON
OFF
ccTalk (Encryption)
ON
OFF
ON
ccTalk (Checksum)
ON
OFF
OFF
MDB
DS3
1 (ON)
2 (OFF)
NOTE: If the LED lights
Red
, the
Color assignment process failed.
Turn the VEGA Power OFF and
perform the procedure again.
Figure 2-6
DIP Switch DS1 (ccTalk Initialize)
Figure 2-6
DIP Switch DS1 (ccTalk Initialize)
NOTE: If the LED lights
Red
, the
Color assignment process failed.
Turn the VEGA Power OFF and
perform the procedure again.
NOTE: DIP Switch settings may vary
based on software changes related
to the specific Country using the
VEGA Unit.
Refer to the Related Country’s
Software Information Sheet.
