P/N 960-100189R_Rev. 4 {EDP #148850}
© 2016, JAPAN CASH MACHINE CO., LTD.
2 - 4
Section 2
VEGA™ Series Banknote Validator
Installation
Connector Pin Assignments
Preventive Maintenance
To retrieve Cash Box deposited Banknotes, perform
the following steps:
1. Pull and remove the Cash Box from the Frame
a
).
2. Rotate the Thumb Lock Knob counterclockwise
and lower the Cash Box Door (Figure 2-7
b
).
3. Retrieve the Banknotes from the Cash Box
c
).
Table 2-5
VEGA Pin Assignments
VEGA Interface Connector
Box Pin Header: PS-16PE-D4LT1-PN (JAE)
Socket Housing: PS-D4C16
Contact Type: 030-51304-001
Recommended Wire: UL1007 AWG #24~26 (Slit Type)
Pin No.
*
Signal Name
I/O
†
Function
1
VDD1
--
12V DC (Option: 24V - 36V DC)
‡
2
VSS1
--
GND
3
RS232C-RXD
IN
Serial data signal input line from Controller to Validator
4
PC-RXD
IN
Serial data signal input line from Controller to Validator
5
PC-TXD(MDB)
OUT
Serial data signal output line from Validator to Controller
6
PC-COM
--
Photo-coupler Common (Ground)
7
VEND3(BUSY)
OUT
Serial data signal output line from Validator to Controller
8
SG
--
Signal Ground
9
INHIBIT3(Soft-R)
IN
Serial data signal input line from Controller to Validator
10
INHIBIT4
IN
Serial data signal input line from Controller to Validator
11
INHIBIT1 (TTL-RXD)
IN
Serial data signal input line from Controller to Validator
12
INHIBIT2(D/E)
IN
Serial data signal input line from Controller to Validator
13
RTS/FULL
OUT
Serial data signal output line from Validator to Controller
14
VEND4(RS232C-TXD)
OUT
Serial data signal output line from Validator to Controller
(RS232C output line alternative)
15
VEND1(cc-Talk)
IN/OUT
**
Serial data signal I/O line from Validator to Controller
16
VEND2(ABN)
OUT
Serial data signal output line from Validator to Controller
*. NOTE: The listed Pin Numbers are different from the Pin Numbers actually printed on the Circuit Board. Be sure that the Pin Numbers printed on the
Connector entry point.
†. I/O (Input/Output) is the Terminal viewed from Banknote Validator’s Bezel opening.
‡. Be sure to use the correct Supply Voltage Specification Parts (Use the 24V DC Specification Item when using 24V - 36V DC Option).
**. ccTalk dual circuit used.
Table 2-5 lists the VEGA Interface Connector Pin Assignments.
As Viewed From Front Side
Retrieving Banknotes
Figure 2-7
Figure 2-7
Retrieving Banknotes
a
b
c
Knob
