P/N 960-100189R_Rev. 4 {EDP #148850}
© 2016, JAPAN CASH MACHINE CO., LTD.
2 - 2
Section 2
VEGA™ Series Banknote Validator
Installation
8. Remove the Course Path Reversing Guide and
bolt the VEGA SD/SU Unit into the VEGA SD/
SU Bracket installed on the Host Machine using
two (2) M4 Screws (Figure 2-4
a
1
&
a
2
) and two
(2) or four (4) M4 Hexnuts.
9. Seat the Cash Box (Figure 2-5
a
) into the Frame
and replace the Course Path Reversing Guide
Cover (Figure 2-5
b
) onto the Upper Section.
10. Turn the VEGA Unit Power
ON
.
DIP Switch Configurations
This portion provides the basic and special DIP
Switch settings for the VEGA Unit.
Basic Settings
To activate the ID-003, ccTalk or MDB Interface on
a VEGA Unit, set DIP Switch Block DS2 Switches
#6 through #8 to ON to select the desired Commu-
nications Interface Protocol (Table 2-2). Then set
DIP Switch Block DS1 Switches #2 through #8 to
ON to select the desired Banknote acceptance/
inhibit settings.
Refer to the related Country’s Software Information
Sheet for further Switch setting details.
Figure 2-3
b
a
c
2
c
1
d
2
d
1
Figure 2-3
Bezel Attachment
NOTE: The bolt length are not to extend
more than 15mm up from the Host
Machine’s base.
Figure 2-4
a
1
a
2
b
2
b
3
b
4
b
1
Figure 2-4
M4 Screw & Nut Removal Locations
NOTE: The number of Screws required
depend on each Host Machine specification
requirements.
Table 2-1
DIP Switch Block 1 Settings
Switch No.
Switch ON
Switch OFF
1
Test Mode
Basic Performance
2
Refer to the Related Country’s
Software Information Sheet
3
4
5
6
7
8
Figure 2-5
Cash Box & Guide Cover Location
a
b
Figure 2-5
Cash Box & Guide Cover Location
NOTE: The setting of Switches #2 through
#8 on DS1, and Switches #1 through #5 on
DS2 are decided by the Related Country’s
Software Information Sheet.
DS1
