106
106
106
106
DIG 2-CH OUTPUT
RADAR
24 supports both the AES/EBU and S/PDIF 2-channel I/O formats. Use this dialog to switch
between the two formats.
AES SETTINGS
(IF AES CARD PRESENT)
SAMPLE RATE IN
This dialog reads the indicator flag for the selected input pair. Use the up and down arrow keys to
select an AES/EBU input pair with a valid signal and the sample rate will be displayed in the dialog.
EMPHASIS
IN
In the early days of digital, emphasis was used to artificially boost the level of high frequency signal
content so that it could be quantized at a higher resolution. The
EMPHASIS IN
dialog indicates if the
incoming AES signal is using emphasis or not.
EMPHASIS
OUT
Use this dialog to turn emphasis flag on and off for the AES output signal. When it is turned on it
indicates to the receiving device that the digital audio stream has been recorded with emphasis and it
should be decoded accordingly.
Since RADAR
24 does not decode emphasis nor store the emphasis flag for audio recorded with
emphasis, the emphasis flag should be turned
ON
if you know with absolute certainty that the digital
audio you recorded had previously been encoded with emphasis.
Emphasis is rarely, if ever, used in the industry today and these options are included primarily for
dealing with legacy recordings.
MULTI-CHNL
TYPE
The number of channels supported by the installed card. For RADAR
24 this value will always be
24-channels.
ADAT SETTINGS (IF ADAT CARD PRESENT)
ADAT IN CLOCK
This dialog sets the input group that ADAT clock information will be derived from. The settings are:
!
AUTOMATIC
!
FIBER C
!
FIBER B
!
FIBER A
DIG 2-CH OUTPUT:
AES/EBU S/PDIF
