20
20
20
20
To set the input and output operating levels:
1. Use the
MENU/PREV
, arrow keys and
ENTER
key to go to the
MAIN / SYS MENU / AUDIO I/O LEVELS
and
press the
ENTER
key.
2. Use the right and left arrow keys to select either
AUDIO IN
or
AUDIO OUT
.
3. Use the up and down arrow keys to select the desired operating level and press the
ENTER
key.
Sync Reference
The sync reference setting will vary widely depending on the application and the configuration of your system.
It will also depend on whether or not RADAR
24 is the master or slave in your particular setup. You can gain
instant access to the sync settings using the
SYNC
key on the
Session Controller
and the
KC-24
.
To make RADAR
24 the digital audio sync master using the word clock output:
1. Ensure that a word clock cable is connected to the
WORDCLOCK/ VIDEO – OUT/THRU
connector.
2. Press
the
SYNC
key on the
Session Controller
or
KC-24
or use the
MENU/PREV
key, arrow keys and
ENTER
key to go to the
MAIN / SYNC MENU / SYNC REFERENCE
menu and press the
ENTER
key.
3. Use the arrow keys to select
SYNC REFERENCE: INTERNAL
and press the
ENTER
key.
4. Use
the
MENU/PREV
key, arrow keys and
ENTER
key to go to the
MAIN / SYNC MENU / SYNC REF OUTPUT
and press the
ENTER
key.
5. Use the right and left arrow keys to select
OUT
and press the
ENTER
key.
For digital audio transfers to a digital mixer or other digital audio device a reliable clock source is mandatory.
Without proper data synchronization digital audio will exhibit pops, clicks and other unpleasant artifacts. In a
film or video post environment video sync is usually distributed to all the video, audio and clock devices in the
studio to ensure that every thing is synchronous with the video signal right down to the sample level. For
synchronizing with analog tape decks that exhibit fluctuations in transport speed, RADAR
24 can even
reference to the incoming SMPTE signal. In this configuration RADAR
24 will fluctuate right along with the
analog master ensuring perfect synchronization at all times!
To slave RADAR
24 to external word clock:
1. Ensure that a word clock source is connected to the
WORDCLOCK/ VIDEO – IN
connector. Make sure that
your projects sample rate in the
MAIN / PROJ MENU / SAMPLE RATE
dialog matches the incoming word
clock frequency.
2. Press
the
SYNC
key on the
Session Controller
or
KC-24
or use the
MENU/PREV
key, arrow keys and
ENTER
key to go to the
MAIN / SYNC MENU / SYNC REFERENCE
menu and press the
ENTER
key.
3. Use the arrow keys to select
SYNC REFERENCE: WORDCLCK : 48 KHZ
and press the
ENTER
key.