EonStor DS S12/S16/S24 Series Hardware Manual
DIMM Slot
Captive Screw
2.5.4
Installing the FBM
(Top Screw)
(Side Screw)
Top Cover
1. Remove the BBU module (see the previous section).
2. Remove the top screw and side screw of the top cover and remove it from the
controller chassis.
3. Install the FBM by orienting and inserting it at an approximately 15 degree angle
into the socket. The socket is located on the charger board.
4. Make sure the FBM’s golden fingers are fully inserted. Press the FBM down. The
retention latches on the socket will hold the FBM in place.
5. Install the RAID controller back into chassis. Insert the controller slowly into the
module slot. When you feel the contact resistance by your hands, use more force,
54
