IFM Electronic Ecomot300 AC2630, Supplementary Device Manual, Page: 13 / 111

ifm Supplementary device manual Interface CANopen in the AS-i controllerE
Getting started General set-up procedure
13
4.2 General set-up procedure
START
END
Address AS-i slaves automatically
during assembling?
Install Har dw ar e:
Power supplies, AS-i network, preaddressed
slaves, optional accessories (repeater, tuner etc.)
Sw itch on pow er supplies (24 V und AS-i)
Switch ControllerE into "Easy startup" mode: [Menu] >
[Address Slav es] > [Easy Startup] > [AS-i Master x]
Connect all AS-i slaves with address 0 one after
another to the AS-i bus
Che ck state of things (1)
LED [24 V PWR] = green continuous light!
LED [PWR / COM] = green continuous light!
LED [PLC RUN] = yellow continuous light!
Check slave lists:
[Menu] > [Slave Lists] > [AS-i Master x] >
[Detected Slaves]
ye s
no
ye s
no
ye s
no
A re all state of the things okay?
A re all state of the things okay?
Setup the AS-i projection:
Current state is to be saved as target state:
[Menu] > [Quick Setup] > [Config. all]
Che ck state of things (2)
LED [CONF / PF] = out!
LED [PROJ] = out!
Check slave lists:
[Menu] > [Slave Lists] > [AS-i Master x] >
[Projected Slaves]
A ddress A S-i slaves via addressing unit
(e.g. AC1144)
Install Har dw ar e:
Power supplies, AS-i network, preaddressed
slaves, optional accessories (repeater, tuner etc.)
Sw itch on pow er supplies (24 V und AS-i)
Troubleshooting (1)
Troubleshooting (2)
→ Troubleshooting (1) (→ page
14 ), Troubleshooting (2) (
→ page
15 )