IDEC MICROSmart FC6A Series, User Manual

Page: 384 / 578

7: HMI F
UNCTION
7-16 FC6A S
ERIES
MICROS
MART
U
SER
’
S
M
ANUAL
FC9Y-B1722
Note: When the Plus CPU module is used,
CPU
Network 2 Settings is displayed.
Select CPU Network 2 Settings with the (up) and (down) buttons and press the (OK) button.
The following operations are the same with CPU Network Settings .
6.
Select Setting with the (up) and (down) buttons and press the (OK) button.
7.
With the (up) and (down) buttons, select ON or OFF .
Notes:

If you specify Data Register , the network settings cannot be configured because they are acquired from the data registers.

The current network settings can be checked from the status monitor.
8.
Press the (OK) button to change the CPU module's DHCP setting and to display the CPU Network Settings 1 screen.
Next, to change the IP address, subnet mask, gateway, preferred DNS server, and alternate DNS server, see the following pages.

"Changing the IP address" on page 7-17, from step
2

"Changing the subnet mask" on page 7-18, from step 2

"Changing the gateway" on page 7-25, from step
2

"Changing the preferred DNS server" on page 7-20, from step 2

"Changing the alternate DNS server" on page 7-21, from step
2
9. Press the (ESC) button to display the screen in the following diagram. Select Yes with the (down) button and press the
(OK) button.
Slave Number
CPU Network Settings
CPU Network 2 Settings
HMI Network Settings
Setting: Fixed
IP Address
192.168. 1. 5
CPU Network Settings
Setting:
Fixed
Data Register:
DHCP
Setting: Fixed
IP Address
192.168. 1. 5
CPU Network Settings
Do you want to
configure network?
No
Yes