IDEC MICROSmart FC6A Series, User Manual

Page: 145 / 578

FC6A S
ERIES
MICROS
MART
U
SER
’
S
M
ANUAL
FC9Y-B1722 2-115
2: P
RODUCT
S
PECIFICATIONS
(4) ACT LED [ACT]
This LED flashes when the module is communicating with the expansion interface remote slave module connected using an
Ethernet cable.
(5) Expansion Connector 1
This connector is used to connect the Plus CPU module or an expansion module.
(6) Expansion Connector 2
This connector is used to connect an expansion module.
(7) Expansion Port [Exp. port M]
This port is used to connect an expansion interface remote slave module using an Ethernet cable.
(8) Ground Terminal
The functional ground terminal.
■
Expansion Interface Remote Slave Module
(1) Power LED [PWR]
This LED turns on when the power is supplied to the expansion interface remote slave module.
(2) Run LED [RUN]
This LED turns on when the expansion interface remote slave module is operating.
(3) Error LED [ERR]
This LED turns on when the following errors occur in the expansion interface remote slave module.

When the cable breaks (data is not normally received for 10 seconds or longer on expansion port 1 [Exp. port S1])

When the following occur for a connected expansion module:
(4) LINK1 LED [LNK]
This LED turns on when the expansion interface remote master module or upstream expansion interface remote slave
module is connected to expansion port 1 [Exp. port S1] using an Ethernet cable.

An unsupported module was connected.
 Exceeded 15 modules.

Exceeded seven modules on the basic expansion side.
 Exceeded eight modules on the expansion interface side.

Initialization error
(11) Power Supply Terminals
(12) Expansion Port 2 [Exp. port S2] Cover
(10) Expansion Port 2 [Exp. port S2]
(9) Expansion Port 1 [Exp. port S1]
(1) Power LED [PWR]
(2) Run LED [RUN]
(3) Error LED [ERR]
(4) LINK1 LED [LNK]
(5) ACT1 LED [ACT]
(6) LINK2 LED [LNK]
(7) ACT2 LED [ACT]
(8) Expansion Connector
FC6A-EXM1S