IDEC FS1A-C11S, User Manual

Page: 37 / 398

INSTALLATION AND WIRING
3-7
C
h
a
p
te
r 3
■ Wiring for spring clamp connector
Do not wire the connector while it is connected to the SafetyOne, as this can damage the
connector and the SafetyOne.
To connect the wire, use a connecting tool (Tyco Electronics Japan Type Number: 1891348-1)
or a commercially-available screwdriver. It is recommended that you use a dedicated
connecting tool to prevent any scratches or damage to the connector housing and spring. When
rewiring, use wire of the same gauge.
● Wiring with a connecting tool
1. Insert the connecting tool into the tool insertion slot on the connector at an angle until the
tool comes to a stop.
2. Insert the wire into wire insertion slot. (If there are any loose strands, twist the wire to make it
even.)
3. With the wire pressed down, remove the connecting tool to finish. Lightly tug on the wire to
check that it is securely connected.
4. To remove the wire, press down the spring with the connecting tool, as if you are connecting
the wire, and pull out the wire.
■ Wiring with a commercially-available screwdriver
Use a screwdriver with a tip width that does not exceed 2.4 mm. Be careful when wiring with a
screwdriver as this can damage the connector.
1. Insert the screwdriver into the tool insertion slot on the connector at an angle, and press
down so as to open the spring. Be careful not to insert the screwdriver with too much force, as
this can damage the connector. Do not insert the screwdriver into the wire insertion slot.
2. With the screwdriver inserted, as described in Step 1 above, insert the wire into wire insertion
slot. (If there are any loose strands, twist the wire to make it even.)
3. With the wire pressed down, remove the screwdriver to finish. Lightly tug on the wire to check
that it is securely connected.
4. To remove the wire, press down the spring with the screwdriver, as if you are connecting the
wire, and pull out the wire.