IBM WebSphere XS40, Command Reference Manual

Page: 763 / 1066

Examples
v
Initiates a packet-capture session on Ethernet 0. Packet-capture data is written to
the file
Eth0Trace
in the general storage directory. The session terminates after
30 seconds or when
Eth0Trace
contains 2500 kilobytes of data (whichever occurs
first).
# packet-capture store://Eth0Trace 1800 2500
Trace begun.
.
.
.
#
v Initiates and then terminates a packet-capture session.
# packet-capture store://Eth0Trace 1800 2500
Trace begun.
.
.
.
# no packet-capture store://Eth0Trace
#
standby
Implements a failover configuration
Syntax
Assign both interfaces to a group using a Virtual IP address (VIP).
standby
group
ip
VIP
Assign a priority to a group.
standby group priority priority
Set the authentication parameters for the group.
standby group auth auth-high auth-low
Add additional IP addresses for a group.
standby group ip-aux IP-address [: IP-address ...]
Indicate preempt mode for the group.
standby group { on | off }
Delete a group from the current interface.
no standby group
Delete all groups from the current interface.
no standby
Parameters
group Identifies the standby group. Use an integer in the range of 1 to 255.
ip VIP Specifies the IP address that one member of this group listens on at any
time. The value must be on the same IP subnet as the primary IP address
of this VLAN.
priority priority
Specifies the priority of the interface. Use an integer in the range of 0 to
255. The default is 100.
The interface with the highest priority becomes the active interface. The
interface with the lesser priority becomes the standby interface. For this
reason, specify a priority of less than 100 for the standby member of the
group.
Chapter 90. VLAN configuration mode
737