IBM WebSphere XS40, Command Reference Manual

Page: 1006 / 1066

var://service/ variable
Address a variable that is made available to a service (such as HTTP or
XSL Co-Processor) that is attached to a multistep session. The majority of
service variables are read-only and cannot be set.
For a complete list of the available service variables, refer to “Service
variables.”
var://system/ variable
Addresses a global variable that is available in all contexts. System
variables persist beyond the multistep scope and can be read by other
objects in the system. If the content of a variable needs to be read or set
outside the scope of the multistep process, use a system variable.
For a complete list of the available global system variables, refer to
“System variables” on page 994.
Note: Table 28 on page 995 lists all of the variables that are available when using a
DataPower appliance.
Service variables
Service variables enable the setting and retrieval of pieces of state that usually
reflect the state of the current transaction.
The available service variables are separated alphabetically into the following
categories:
v
General service variables that are available to all DataPower services
v
Service variables that are available only to Multi-Protocol Gateway services and
to Web Service Proxy services
v
Configuration services
v
Load balancer service
General service variables
This section contains information about general variables in alphabetic order by
permission category. General variables are available to all services. Table 12 lists the
names and permission for these variables.
Table 12. Names and permissions for variables that are available to all DataPower services
Variable name Permission
var://service/soap-fault-response
Read-write
var://service/system/ident
Read-only
var://service/system/status/ status-enumeration
Read-only
Read-only variables
var://service/system/ident
Gets the system identification information. This information includes the
product number, the model, the configured name of the DataPower
appliance, and the serial number.
var://service/system/status/ status-enumeration
Gets the contents of a specific status object. You must include the
enumeration value of the status object. Refer to the
StatusEnum
type in the
store:///xml-mgmt.xsd
schema for the list of the available status objects.
980
Command Reference