IBM WebSphere XS40, Command Reference Manual

Page: 675 / 1066

Chapter 75. Stateless Raw XML Handler configuration mode
This chapter provides an alphabetic listing of commands that are available in
Stateless Raw XML Handler configuration mode.
To enter this configuration mode, use the Global source-raw command. While in
this mode, define the client-side traffic handler.
All of the commands listed in “Common commands” on page 2 and most, but not
all, of the commands listed in Chapter 114, “Monitoring commands,” on page 949
are available in these configuration modes.
acl
Assigns an Access Control List (ACL).
Syntax
acl name
no acl name
Parameters
name Identifies the ACL to be assigned to the Stateless Raw XML Handler.
Guidelines
Only those IP addresses explicitly granted access by the assigned ACL are able to
access the Stateless Raw XML Handler.
Use the no acl command to remove an ACL from a Stateless Raw XML Handler.
Examples
v
Enters Stateless Raw XML Handler configuration mode to create the
sansTCP
Stateless Raw XML Handler. Assigns the
aclRestrictive-1
ACL to the handler.
# source-raw sansTCP
Stateless Raw XML Handler configuration mode
# acl aclRestrictive-1
#
v
Removes the
aclRestrictive-1
ACL from the current Stateless Raw XML
Handler.
# no acl aclRestrictive-1
#
local-address
Specifies the local interface to monitor for client requests.
Syntax
local-address { address | 0 }
© Copyright IBM Corp. 1999, 2008
649