IBM TotalStorage NAS Gateway 500, Service Manual

Page: 65 / 471

MAP 0410: Repair Checkout
Purpose of this MAP
This MAP is used to check out the system after a repair is completed..
Note: Use Standalone Diagnostics for repair checkout only when no other diagnostics are available on the
system. Standalone Diagnostics do not log repair actions.
Step 0410-1
Did you use a hot-swap operation to change the FRU?
NO Go to “Step 0410-2”.
YES Go to “Step 0410-5”.
Step 0410-2
Note: If the system planar or battery has been replaced, it might be necessary for the customer to set the
boot sequence for this system before diagnostics can be loaded. The system time and date
information should also be set when the repair is completed.
Do you have cards, adapters, cables, devices, or any other FRUs that were removed during
problem analysis that you want to put back into the system?
NO Go to “Step 0410-4”.
YES Go to “Step 0410-3”.
Step 0410-3
1. After performing a system shutdown, turn off the system power and unplug all power cords (cables)
from electrical outlets.
2. Install all of the cards, adapters, cables, devices, and any other FRUs that were removed during
problem analysis.
3. Go to step “Step 0410-4”.
Step 0410-4
1. Set slow boot using the service processor Enable/Disable Fast System Boot menu. See “System
power control menu” on page 265.
2. Power on the system.
3. Wait until the system login prompt displays or until apparent system activity on the operator panel or
console has stopped.
Did the login prompt display?
NO Go to “MAP 1020: Problem Determination” on page 49.
YES Go to “Step 0410-7” on page 46.
Step 0410-5
Is the system containing the FRU running service mode diagnostics?
NO Go to “Step 0410-7” on page 46.
YES Go to “Step 0410-6” on page 46.
Chapter 3. Maintenance Analysis Procedures (MAPs)
45