IBM TotalStorage NAS Gateway 500, Service Manual

Page: 132 / 471

Table 10. Firmware checkpoints (continued)
Checkpoint Description Action or
possible failing FRU
E561 Set up RIO interface chip registers If the location code associated with this
checkpoint is either U0.1-P1 or U0.1-P2, do
the following:
1. Replace the PCI riser card in the CEC
drawer, location: U0.1-P2.
2. Replace the CEC backplane: location
U0.1-P1.
Otherwise, replace the device specified by
the location code.
E562 Set up RIO interface chip registers If the location code associated with this
checkpoint is either U0.1-P1 or U0.1-P2, do
the following:
1. Replace the PCI riser card in the CEC
drawer, location: U0.1-P2.
2. Replace the CEC backplane: location
U0.1-P1.
Otherwise, replace the device specified by
the location code.
E563 Set up RIO interface chip registers If the location code associated with this
checkpoint is either U0.1-P1 or U0.1-P2, do
the following:
1. Replace the PCI riser card in the CEC
drawer, location: U0.1-P2.
2. Replace the CEC backplane: location
U0.1-P1.
Otherwise, replace the device specified by
the location code.
E564 Set up RIO interface chip registers If the location code associated with this
checkpoint is either U0.1-P1 or U0.1-P2, do
the following:
1. Replace the PCI riser card in the CEC
drawer, location: U0.1-P2.
2. Replace the CEC backplane: location
U0.1-P1.
Otherwise, replace the device specified by
the location code.
E565 Set up RIO interface chip registers If the location code associated with this
checkpoint is either U0.1-P1 or U0.1-P2, do
the following:
1. Replace the PCI riser card in the CEC
drawer, location: U0.1-P2.
2. Replace the CEC backplane: location
U0.1-P1.
Otherwise, replace the device specified by
the location code.
112
NAS Gateway 500 Service Guide