Table 16. BA000010 to BA400002 Partition firmware SRCs (continued)
v
Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
v
See Chapter 3, “Parts listing, Type 8406,” on page 229 to determine which components are CRUs and which
components are FRUs.
Error code
Description
Action
BA01D040
The DHCP discover server timed out
1.
Verify that the DHCP server has addresses
available.
2.
Verify that the DHCP server configuration
file is not overly constrained. An
over-constrained file might prevent a server
from meeting the configuration requested
by the client.
3.
Perform the following actions that
checkpoint CA00E174 describes:
a.
Verify that:
v
The bootp server is correctly
configured; then, retry the operation.
v
The network connections are correct;
then, retry the operation.
b.
If the problem persists:
1)
Go to “Checkout procedure” on
page 184.
2)
Replace the system-board, as
described in “Replacing the FRU
system-board and chassis assembly”
on page 260.
BA01D050
DHCP::discover no good offer
DHCP discovery did not receive any DHCP
offers from the servers that meet the client
requirements.
Verify that the DHCP server configuration file
is not overly constrained. An over-constrained
file might prevent a server from meeting the
configuration requested by the client.
BA01D051
DHCP::discover DHCP request timed
out
DHCP discovery did receive a DHCP offer
from a server that met the client requirements,
but the server did not send the DHCP
acknowledgement (DHCP ack) to the client
DHCP request.
Another client might have used the address
that was served.
Verify that the DHCP server has addresses
available.
BA01D052
DHCP::discover: 10 incapable servers
were found
Ten DHCP servers have sent DHCP offers,
none of which met the requirements of the
client. Check the compatibility of the
configuration that the client is requesting and
the server DHCP configuration files.
BA01D053
DHCP::discover received a reply, but
without a message type
Verify that the DHCP server is properly
configured.
58
Power Systems: Problem Determination and Service Guide for the IBM Power PS700 (8406-70Y)
