Husqvarna 2011 SMS 630, Workshop Manual, Page: 78 / 455

E.20 Part. N. 8000 H2051 (02-2010)
H00001
1
1
1
2
H01160
GENERAL PROCEDURES
Fuel tank disassembly (scoops and fuel pump)
Before disassembling the tank, open both fuel cocks and drain it
completely.
- Remove the fuel tank as described in the relevant paragraph.
- Raise the cover (1), insert the key, turn it and remove the cap (2).
- Use a 3 mm Allen wrench to loosen the M5 screws (3) and a 4 mm Allen
wrench to loosen the M6 screw (4); then remove the fuel cap flange.
- Loosen the screws (7) using an 8 mm ring wrench and remove right (5) and
left scoops (6).
On assembly, make sure the bushings (8) are correctly positio-
ned in the scoops before tightening the screws (7).
- Loosen the screws (9) using an 8 mm ring wrench and remove the fuel pump
(10)
IMPORTANT: Make sure to position gasket (11) correctly on assembly.
- Use a screwdriver to loosen the screws (12) and remove the cocks (13).
IMPORTANT: Make sure to position gaskets (14) correctly when refitting the
cocks.
- Reassemble all parts in the reverse order compared to disassembly and
tighten screws to the specified torque (see Section X)