Husqvarna 2011 SMS 630, Workshop Manual, Page: 448 / 455

Y.7 Part. N. 8000 H2051 (02-2010)
CHASSIS AND WHEELS
Reassembling the front wheel
Fit the L.H. spacer (D) on the wheel hub.
(TE)
Fit the wheel between the fork legs so as to set the brake disc into the calliper.
FINAL RATIOS (SMS)
Fit the wheel between the fork legs.
Fit the wheel axle (2) from the R.H. side, after greasing it and push it fully home
against the L.H. fork leg; during this operation, the wheel should be turned.
Tighten the screw (3) on the fork L.H. side but DO NOT lock it. Now, pump for a
while, pushing the handlebar downwards until you are sure that the fork legs are
perfectly aligned. Lock: the screws (1) on the R.H. leg (10.4 Nm, 1.05 Kgm, 7.7
ft/lb), the screw (3) on the L.H. side (51.45 Nm, 5.25 Kgm, 38 ft/lb), the screws
(1) on the L.H. leg ( 10.4 Nm, 1.05 Kgm, 7.7 ft-lb).
(SMS)
Fit the brake calliper on the disc; assemble the calliper on its mounting plate and
tighten the two screws (A) to 25.5 Nm/ 2.6 Kgm/ 18.8 ft-lb. Ensure that the brake
disc slides between the calliper pads without any friction or hard spots.
After reassembly, pull the brake control lever until the pads are
against the brake disc.