Hughes Direcway DW6000, Installation Manual

Page: 38 / 214

Chapter 2 • Installing the DW6000 using satellite-based commissioning (SBC)
16
1033295-0001 Revision A
The power supply
There are two power supplies available for use with the DW6000:
•
AC/DC power supply (part number 1031105-0001, model
ADP-0641-M2)
•
DC/DC power supply (part number 1033554-0001, model
DC-0651-M3)
Always use the power supply provided with the DW6000 system.
The power supply part number is listed on a sticker that is
attached to the power supply. Refer to the sticker to verify you
have the correct power supply.
Note: In this manual, only the AC/DC power supply is shown in
graphics depicting power supply connections.
CAUTION
•
This unit’s performance may suffer if the wrong power
supply is used.
•
NEVER pull the DC power cord from the back of the
DW6000. Doing so could damage the pins and also
cause a short in the system.
•
When power needs to be removed from a DW6000 that
uses an AC/DC power supply, ALWAYS unplug the AC
power cord from the wall outlet, surge protector, or
power strip.
•
When power needs to be removed from a DW6000 that
uses a DC/DC power supply, ALWAYS unplug the DC
input cable connector from the power supply.
•
Power supply with the part number 1031105-0001 is to
be used only in the United States and Canada.
•
AC/DC power supplies must be used with 110-volt AC
input.
•
If the DW6000 will be installed outside the United States
and Canada, always observe the power standards and
requirements of the country where it will be installed.