Hughes Direcway DW6000, Installation Manual, Page: 85 / 214

Chapter 3 • The System Control Center
1033295-0001 Revision A
63
If the connectivity test succeeds, try pinging the Router
Address from the computer. This address can be obtained
from the
System Information page. To ping, use the same set
of instructions that are in If the System Control Center is not
accessible on page 48, except type the Router Address.
If this succeeds, skip to the Internet Connectivity test below.
If this fails, the default gateway address is probably not set
correctly in the computer’s network settings. The default
gateway address should be the DW6000 IP address received
during commissioning. The IP address is displayed on the
System Information page. Fix this in the computer's network
settings and repeat the connectivity test.
If the connectivity test still fails, power-cycle the DW6000 by
unplugging the power cord from the power source and
plugging it back in. If this does not fix the problem, call
installer support.
Figure 55: Connectivity Test