Hughes Direcway DW6000, Installation Manual

Page: 40 / 214

Chapter 2 • Installing the DW6000 using satellite-based commissioning (SBC)
18
1033295-0001 Revision A
Assembling the DW6000
and connecting it to the
installer PC 1. Take the pedestal base in one hand and the DW6000 in the
other. Orient them as shown in Figure 8. The Power LED will
be at the bottom.
2. The DW6000 has two curved ridges, one on each side of its
opening. See Figure 9. The pedestal base has six guides that
slide along these ridges. See Figure 10. Locate the ridges and
the two guides at the front of the pedestal base.
3. Align the guides with the ridges.
4. Gently slide the guides along the ridges until the DW6000
clicks into place.
Note: Some installation and troubleshooting steps require you to
power-cycle the DW6000. When power-cycling a DW6000 that
uses an AC/DC power supply, always disconnect the AC power
cord from the power source. When power-cycling a DW6000 that
uses a DC/DC power supply, always disconnect the DC input cable
connector from the power supply.
Note: If you need to remove the DW6000 from the pedestal
base, pull up and back on the clip on the back of the base. See
Figure 11. You can then slide the base off the DW6000.
Figure 8: Orienting pedestal base and DW6000