Appendix A • Installing the DW6000 using dial-up commissioning
1033295-0001 Revision A
93
Modem installation
method
Follow the steps below and refer to the illustrations on page 93
through page 96 to install the DW6000.
Before beginning the installation, be sure that you have installed
the installation software correctly. See
Installing the installation
software
on page 87. In addition, confirm that TCP/IP is enabled
to obtain IP addresses automatically on your installer laptop PC.
See Appendix C –
on page 141
.
1. Take the pedestal base in one hand and the DW6000 in the
other. Orient them as shown in Figure 73. The Power LED
will be at the bottom.
2. The DW6000 has two curved ridges, one on each side of its
opening. See Figure 74. The pedestal has six guides that slide
along these ridges. See Figure 75. Locate the ridges and the
two guides at the front of the pedestal base.
3. Align the guides with the ridges.
Note:
Some installation and troubleshooting steps require you to
power-cycle the DW6000. When power-cycling a DW6000 that
uses an AC/DC power supply, always disconnect the AC power
cord from the power source. When power-cycling a DW6000 that
uses a DC/DC power supply, always disconnect the DC input cable
connector from the power supply.
CAUTION
Do not connect the power supply to the DW6000, or connect
the power supply to a power source, before instructed to do
so.
CAUTION
• Do not block any ventilation openings. Do not install near
any heat sources such as radiators, heat registers,
ovens, stoves, or other apparatus (including amplifiers)
that produce heat.
• Recommended ventilation space around the top and
sides of the DW6000 assembly should be approximately 6
inches. Ventilation is necessary to avoid overheating.
Summary of Contents for Direcway DW6000
