Hughes Direcway DW6000, Installation Manual

Page: 33 / 214

Chapter 2 • Installing the DW6000 using satellite-based commissioning (SBC)
1033295-0001 Revision A
11
•
A 6-foot Cat-5 Ethernet cable to connect the DW6000 to the
customer’s computer. If a longer cable is needed, the
customer must supply it. Either crossover or straight-through
Cat-5 Ethernet cable can be used.
•
A power strip or surge protector. If one of these is not present,
proceed with the installation using the wall outlet or other
power source.
•
An analog phone line if not using SBC.
Note: If the customer wants to connect a network to the
DW6000, he or she must do so via an Ethernet hub or other such
equipment. The customer must supply and configure the hub and
cables. IP address information is provided during commissioning.
Note: Before beginning the installation, confirm your laptop’s
TCP/IP settings are configured to "Obtain an IP address
automatically." See Appendix D – on page 115.
CAUTION
Do not connect the power supply to the DW6000, or connect
the power supply to a power source, before instructed to do
so.
CAUTION
• Do not block any ventilation openings. Do not install near
any heat sources such as radiators, heat registers,
ovens, stoves, or other apparatus (including amplifiers)
that produce heat.
• Recommended ventilation space around the top and
sides of the DW6000 assembly should be approximately 6
inches. Ventilation is necessary to avoid overheating.