Hughes Direcway DW6000, Installation Manual

Page: 56 / 214

Chapter 2 • Installing the DW6000 using satellite-based commissioning (SBC)
34
1033295-0001 Revision A
The test status, isolation value, and the pass/fail result are
displayed in the Cross Pol Test window. See Figure 32.
16. Adjust the antenna during the manual cross-pol test to
achieve maximum transmit isolation.
17. Bolt down the antenna when the unit consistently passes the
manual cross-pol test.
18. Click Close to close the Cross Pol Test window.
19. Click Automatic on the Transmit Antenna Pointing screen to
initiate the automatic cross-pol (ACP) test.
Re-peak the transmit isolation in manual mode if the unit
does not pass the ACP test.
20. Click Close to close the Cross Pol Test Window if the unit
passes the ACP test.
21. Click Next on the Transmit Antenna Pointing screen if the
unit passed the automatic cross-pol test.
22. Select a registration server from the drop-down menu on the
Registration Server Selection screen. See Figure 33. Refer to
the installation specification or work order if you are unsure
which server to select.
You may also access the registration server by manually
entering its address. Follow these steps if you must manually
enter the registration server’s address:
a. Select the Enter Registration Server address manually
check box.
b. Enter the registration server’s address in the
HTTP://
field.
c. Select the
Secure HTTP Mode
check box to enable a
secure connection to the registration server.
Figure 32: Manual cross-pol test results
Note: The manual cross-pol test will time-out 5 minutes after
clicking on the Manual button. Make sure any antenna adjustments
required to achieve maximum transmit isolation are completed
within this time frame.