Hughes Direcway DW6000, Installation Manual

Page: 113 / 214

Appendix A • Installing the DW6000 using dial-up commissioning
1033295-0001 Revision A
91
Qualifying the customer’s
PC with the qualification
tool
Insert the disk containing the customer PC qualification tool in
the customer’s computer. Run all the checks in the tool to ensure
the customer’s computer is set up to work with the DW6000.
The tool does not work on a MacIntosh computer.
The power supply
There are two power supplies available for use with the DW6000:
•
AC/DC power supply (part number 1031105-0001, model
ADP-0641-M2)
•
DC/DC power supply (part number 1033554-0001, model
DC-0651-M3)
Always use the power supply provided with the DW6000 system.
The power supply part number is listed on a sticker that is
attached to the power supply. Refer to the sticker to verify you
have the correct power supply.
Note: In this manual, only the AC/DC power supply is shown in
graphics depicting power supply connections.
CAUTION
•
This unit’s performance may suffer if the wrong power
supply is used.
•
NEVER pull the DC power cord from the back of the
DW6000. Doing so could damage the pins and also
cause a short in the system.
•
When power needs to be removed from a DW6000 that
uses an AC/DC power supply, ALWAYS unplug the AC
power cord from the wall outlet, surge protector, or
power strip.
•
When power needs to be removed from a DW6000 that
uses a DC/DC power supply, ALWAYS unplug the DC
input cable connector from the power supply.
•
Power supply with the part number 1031105-0001 is to
be used only in the United States and Canada.
•
AC/DC power supplies must be used with 110-volt AC
input.
•
If the DW6000 will be installed outside the United States
and Canada, always observe the power standards and
requirements of the country where it will be installed.