HP rp4410, Service Manual

Page: 57 / 246

NOTE:
To identify each item by part number, see the sales order packing slip.
Returning Damaged Equipment
If the equipment is damaged, contact your HP customer service representative immediately. The
service representative initiates appropriate action through the transport carrier or the factory
and assists you in returning the equipment.
Unloading the Server with a Lifter
WARNING!
Use caution when using a lifter. Because of the weight of the server, you must
center the server on the lifter forks before lifting it off the pallet to avoid injury.
To unload the server from the pallet using a lifter, follow these steps:
1. Unpack the server. See “Unpacking the Server” (page 56) .
2. Unroll the bottom corrugated tray corresponding to the side on which the lifter will be
placed, and slide the server as close to that edge of the pallet as possible.
3. Break off any foam packaging that can prevent the lifter from being fully inserted under the
server.
IMPORTANT: Do not remove the foam packaging from the corners of the server. This foam
is required to elevate the server and enable the forks of the lifter to be placed under the
server.
4. Insert the lifter forks under the server.
5. Carefully roll the lifter forward until it is fully positioned against the side of the server.
6. Slowly raise the server off the pallet until it clears the pallet cushions.
7. Carefully roll the lifter and server away from the pallet. Do not raise the server any higher
than necessary when moving it over to the rack.
Installing Additional Components
This section describes how to install server components that are not installed before delivery.
Service Tools Required
Service of this product can require one or more of the following tools:
• Electrically Conductive Field Service Kit (HP part number 9300-1155)
• 1/4 inch flat blade screwdriver
• ACX-15 Torx screwdriver
• Special processor tool kit (HP part number 5069-5441)
Installing Additional Components 57