HP rp4410, Service Manual

Page: 104 / 246

Figure 3-40 Ports on Server Rear
To enable general network connectivity for the server, follow these steps:
1. Obtain a valid IP address for each LAN port you plan to activate.
2. Connect the LAN cable from an available LAN port into a live connection on the network.
Console Setup
This section describes how to set up and start a console session on the server.
Setting Up the Console
Setting up the console includes the following steps:
•
Determine the physical access method to connect cables. There are two physical connections
to the iLO MP:
— LAN
— Local RS-232 serial port
• Configure the Integrity iLO MP and assign an IP address if necessary. Though there are
several methods to configuring the LAN, DHCP with DNS is the preferred method. DHCP
with DNS comes pre-configured with default factory settings, including a default user
account and password. Other options include:
— ARP Ping
— Local RS-232 serial port
— Remote/modem port
Setup Checklist
To assist with the iLO MP setup process, use the checklist in Table 3-13 .
104 Installing the System