
1.
Ensure the emulation software device is properly configured. The terminal emulation device
runs software that interfaces with the server. The software emulates console output as it
would appear on an ASCII terminal screen and displays it on a console device screen.
2.
To ensure the emulation software is correctly configured, do the following:
a.
Verify that the communication settings are configured as follows:
•
8/none (parity)
•
9600 baud
•
None (receive)
•
None (transmit)
b.
Verify that the terminal type is configured appropriately. Supported terminal types are
as follows:
•
hpterm
•
vt100
•
vt100+
•
vt-utf8
IMPORTANT:
Do not use hpterm and vt100 terminal types at the same time.
There are many different emulation software applications. Consult the help section of your
emulation software application for instructions on how to configure the software options.
3.
To determine the required connection components and the ports used to connect the server
to the console device, use
4.
Connect the cables.
a.
Connect the DB-9 end of the RS-232 serial port female-to-female cable to the console
RS-232 serial port.
b.
Connect the other end of the DB-9 female-to-female cable to the console device.
5.
Start the emulation software on the console device.
6.
Log in to the iLO MP. See
“Logging In to the iLO MP” (page 110)
7.
At the
MP Main Menu
, enter
CM
and press
Enter
to select command mode.
8.
At the command mode prompt, enter
LS
and press
Enter
. The screen displays the default
LAN configuration values.
9.
Write down the default values or log the information to a file for future troubleshooting.
10. To disable DHCP, use the
LC
command.
a.
From the
LC
command menu, enter
D
and press
Enter
.
b.
To change the DHCP status from Enabled to Disabled, follow the instructions on the
screen.
c.
To reset the iLO MP, enter
XD -R
.
11. To enter information for the IP address, host, subnet mask, gateway parameters, and so on,
use the
LC
command.
12. To reset the iLO MP, enter
XD -R
.
13. After the iLO MP resets, log in to the iLO MP again and enter
CM
at the
MP>
prompt.
14. To confirm that DHCP is disabled and display a list of updated LAN configuration settings,
enter
LS
.
Logging In to the iLO MP
To log in to the iLO MP, follow these steps:
1.
Access the iLO MP using the LAN, RS-232 serial port, telnet, SSH, or web method. The iLO
MP login prompt displays.
110
Installing the System
Summary of Contents for rp4410
