HP L1000 - 9000 - 0 MB RAM, User Manual

Page: 70 / 231

Chapter 4
Cable Connections
Configure System Consoles
56
HP 700 Series System Console Configuration
The following describes the steps required to configure the HP 700 series terminal for VT-100 mode for
operation with an rp54xx server.
Although any terminal capable of operating in VT-100 mode can be used, the HP700 series terminal is used
here as an example because it is fairly common and it’s configuration is typical of many terminals currently in
use.
HP700 VT-100 Mode Configuration The following procedure outlines the steps to configure the HP700
series terminal for VT100 operation.
NOTE You may use either the arrow keys or the tab key to move between the setting options on the
screen.
1. Press
[config keys]
function key. [f8]
2. Press
[terminal config]
function key. [f5]
3. Move to Terminal ID and enter “vt100”.
4. Move to Set TermMode and, using the [Prev] and [Next] keys, select “EM100”.
5. Press the [config keys] function key . [f8]
6. Press the [ansi config] function key . [f6]
7. Move to “multipage” and, using the [Prev] and [Next] keys, select “yes”.
(Enables screen scrolling).
8. Move to Backspace Del and, using the [Prev] and [Next] keys, select “Backspace/Del”.
9. Move to EM100 ID and, using the [Prev] and [Next] keys, select “EM100”.
Configure the Asynchronous Values of the GSP
After the ASCII console has been configured and physical connections made, make any necessary changes to
the asynchronous values of the GSP.
1. Access the GSP with the ctrl+b entry. The GSP will respond with a
GSP>
prompt.
2. At the GSP prompt, enter the Configure Asynchronous (ca) command:
The ca command will start a series of prompts. Respond to each prompt with the appropriate information.
Example 4-1 CA command
Leaving Console Mode - you may lose write access. When Console Mode returns, type
^Ecf to get console write access.
GSP Host Name: fesrhapgsp
GSP> ca
CA This command allows you to modify the local and remote modem serial
portconfigurations.
Current configuration settings:
Local Console Serial Port bit rate: 9600 bits/s
Local Console Serial Port Flow Control: Software