HP L1000 - 9000 - 0 MB RAM, User Manual

Page: 43 / 231

Chapter 3
Installing Additional Components
Installing Memory
29
a. Locate the Memory Carrier and pull up on the extractor levers on each end of the Memory
Carrier to unseat the Memory Carrier from its socket.
b. When the Memory Carrier unseats from the socket, pull it away from the System Board.
c. Loosen the captive screws that secure the DIMM Clip and remove the DIMM Clip from the
Memory Carrier.
d. Seat the memory DIMM into its socket on the Memory Carrier.
e. Press the extractor levers on each end of the memory DIMM slot inward until the levers snap
into place.
f. Attach the Memory Clip to the Memory Carrier with the DIMM slot markings on the top of the
Memory Clip aligned with the DIMM slot markings on the Memory Carrier.
g. Secure the Memory Clip using the captive screws.
h. Seat the Memory Carrier into the appropriate slot on the System Board.
i. Push down on the extractor levers and snap them into place.
Step 7. Replace the air baffle. Tighten the four captive screws to secure the air baffle in place.
Step 8. Replace the top cover. Slide the cover tabs into the slots in the chassis and close the cover. Tighten
the two captive screws to secure the top cover in place.
Step 9. For rack configurations, insert the rp54xx server back into the rack.
Step 10. For deskside enclosure configurations, replace the deskside enclosure cover.
Step 11. Power the rp54xx server on.
Step 12. Use the BCH command
in me
to verify the system recognizes the memory that you have just
added.