Function Group
Menu Map
Description
Programming Codes
See Also
FREQUENCY
NONE
This
lets you select the center frequency for center
frequency/frequency span swept operation. When you press [CENTER),
the swept signal generator displays:
CENTER:
XXXXX MHz,
where
XXXXX represents a frequency value. Use the entry area to set the
desired value.
Certain center frequency and frequency span combinations cause the
swept signal generator to limit the value entered. In general, any
combination that would cause the swept signal generator to exceed
its minimum or maximum specified frequency will be limited.
FREQuency:CENTer <num>[freq suffix] or
FREQuency:MODE
Analyzer:
CF
(SPAN), (START), (STOP)
“Center Frequency/Span Operation” in Chapter 1
Operating and Programming Reference C-l
Summary of Contents for 8360 B Series
Page 363: ...NF N 2 w z P w D I oa 0 i B 6 7 On s5 n 20 a g 9 i T2 ...
Page 406: ...2b Menu Maps Menu Maps 2b 1 ...
Page 407: ...t t m ALC Bandwidth Select Module Sense Low High Auto AUTO Front Rear None ALC MENU ...
Page 412: ...rMENU SELECT 1 Fault Fault Info1 Info2 Fault Info3 Clear Fault S E R V I C E M E N U 6 ...