Setup Swept Signal Generator Parameters
6.
On the swept signal generator, press (PRESET).
7.
FREQUENCY
(STOP)
8.
9.
10.
11.
12.
13.
14.
Access User Flatness Correction Menu
Press POWER
Select Fltness
Menu.
Select Delete Menu Delete All. This step insures that the
flatness array is empty.
Press
Leave the delete menu and return to the previous
soft key menu.
Enter the frequency points at which the correction information
will be taken. Choose either the point-by-point entry method
Enter
or the automatic frequency point generation
Auto Fill Start. For this example, select Auto Fill Start
Select Auto Fill Stop
Auto Fill
Notice that a frequency list starting at 4 and ending at 10
with an increment value of 1
is created.
Enter Correction Data into Array
Select Mtr
Menu Measure Corr All . The power meter
is now under swept signal generator control and is performing
the sequence of steps necessary to generate the correction
information at each frequency point.
If an HP-IB error message is displayed verify that the interface
connections are correct. Check the HP-IB address of the power
meter and ensure that it is the same address the swept signal
generator is using (address 13 is assumed). Refer to the menu
map 8, System, for the key sequence necessary to reach
Meter Adrs .
Enable User Flatness Correction
15. When the operation is complete, (a message is displayed) the
flatness correction array is ready to be applied to your setup.
Disconnect the power meter/sensor and press
ON
/
OFF
)
(amber LED on). T he p ower produced at the point where the
meter/sensor was disconnected is now calibrated at the
frequencies and power level specified above.
Getting Started Advanced 1-35
Summary of Contents for 8360 B Series
Page 363: ...NF N 2 w z P w D I oa 0 i B 6 7 On s5 n 20 a g 9 i T2 ...
Page 406: ...2b Menu Maps Menu Maps 2b 1 ...
Page 407: ...t t m ALC Bandwidth Select Module Sense Low High Auto AUTO Front Rear None ALC MENU ...
Page 412: ...rMENU SELECT 1 Fault Fault Info1 Info2 Fault Info3 Clear Fault S E R V I C E M E N U 6 ...