HP 8360 B Series, User Manual

Page: 254 / 496

M
Function Group
MARKER
Menu Map
Description This lets you set the swept signal generator to start sweeping
at the frequency of marker 1 (Ml), and stop sweeping at the
frequency of marker 2 (M2). M2 must have a higher frequency
value than Ml. If
Sweep is activated when M2 is at a
lower frequency than Ml, the values of Ml and M2 are permanently
interchanged. While this function is active, the start/stop frequencies
of the swept signal generator are changed to the values of Ml and
M2. An asterisk next to the key label indicates this feature is active.
Programming Codes
SCPI:
SWEep:MARKer:STATe
Analyzer:
function on, MPO function off.
See Also
M a r k e r
“Marker Operation” in Chapter 1
“Programming Typical Measurements” in Chapter 1
Function Group
SWEEP
Menu Map
Description This lets you set the swept signal generator to the manual
sweep mode of operation. Depending on what parameter is sweeping,
you can use either the rotary knob or the ARROW keys to manually
sweep between the start/stop limits. In manual sweep mode, the
swept signal generator does not automatically retrace at the sweep
end point (the user must turn the rotary knob to retrace), and the
green SWEEP LED does not light. The resolution of the rotary
knob is 0.1% of the sweep span in either start/stop or
mode.
The resolution of the and arrow keys are dependent on the
Operating and Programming Reference M-l