AUTO
How
the list is played back.
Each new frequency point is
stepped to automatically,
after waiting the specified
time.
AUTO
BUS
Wait for a <GET> or
the HP-IB before
advancing to the next
frequency in the list.
AUTO
Wait for a signal to be
received on the external
input before advancing to
the next frequency in the
list.
Don’t care
Only the list point
specified by LIST:MANual
is played back.
*RST state is
AUTO.
l
LIST[:POWer]:CORRection
l
Sets and queries the list of correction levels that correspond to each
of the frequencies entered using the
LIST:FREQ command.
The
attenuator is not allowed to change during the list execution. The
number of parameters can be from
1 to 801.
After
the value is 0.
l
Returns the number of correction points that have been entered into
the list array. After *RST returns a
1.
l
LIST:TRIGger:SOURce
l
LIST:TRIGger:SOURce?
Sets and queries the list point-to-point trigger source when in the
automaticlistmode. See LIST:MODE and
more details.
*RST state is
l
l
Sets and queries the amplitude marker on/off switch. While [n] may
be used, there is really only a single switch for all the markers.
*RST
value is OFF.
l
MARKer[n]:AMPLitude:VALue
l
MARKer[n]:AMPLitude:VALue?
Sets and queries the value of the amplitude marker. While [n]
may
Operating and Programming Reference S-39
Summary of Contents for 8360 B Series
Page 363: ...NF N 2 w z P w D I oa 0 i B 6 7 On s5 n 20 a g 9 i T2 ...
Page 406: ...2b Menu Maps Menu Maps 2b 1 ...
Page 407: ...t t m ALC Bandwidth Select Module Sense Low High Auto AUTO Front Rear None ALC MENU ...
Page 412: ...rMENU SELECT 1 Fault Fault Info1 Info2 Fault Info3 Clear Fault S E R V I C E M E N U 6 ...