Honeywell ORBIT 7120PLUS, User Manual, Page: 77 / 241

Orbit 7120plus/7190g User Guide 63
Intercharacter, Interfunction, and Intermessage Delays
Some terminals drop information (characters) if data comes through too quickly.
Intercharacter, interfunction, and intermessage delays slow the transmission of
data, increasing data integrity.
Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed between the transmission of each character of scanned data. Scan the
Intercharacter Delay bar code below, then scan the number of 5ms delays, and
the Save bar code from the Programming Chart, beginning on page 225.
To remove this delay, scan the Intercharacter Delay bar code, then set the number
of delays to 0 . Scan the Save bar code from the Programming Chart, beginning on
page 225.
Note: Intercharacter delays are not supported in USB serial emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed after the transmission of a particular character of scanned data. Scan the
Delay Length bar code below, then scan the number of 5ms delays, and the Save
bar code from the Programming Chart, beginning on page 225. Next, scan the
Character to Trigger Delay bar code, then the 2-digit hex value for a printable
character to trigger the delay (see Lower ASCII Reference Table on page 215.
)
1 2 3 4 5
Intercharacter Delay
Prefix S canned Data Su ffix
Intercharacter Delay
Delay Length
Character to Trigger Delay