Honeywell ORBIT 7120PLUS, User Manual

Page: 51 / 241

Orbit 7120plus/7190g User Guide 37
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the bar code below,
then set the delay (from 0 - 30,000 milliseconds) by scanning digits from the inside
back cover, then scanning
Save .
Serial Trigger Mode
You can activate the scanner by using a serial trigger command (see Trigger
Commands on page 178). When in serial mode, the scanner scans until a bar code
has been read or until the deactivate command is sent. The scanner can also be set
to turn itself off after a specified time has elapsed (see
Read Time-Out , which fol-
lows).
Read Time-Out
Use this selection to set a time-out (in milliseconds) of the scanner’s trigger when
using serial commands to trigger the scanner. Once the scanner has timed out, you
can activate the scanner by using a serial trigger command. After scanning the
Read Time-Out bar code, set the time-out duration (from 0-300,000 milliseconds)
by scanning digits from the Programming Chart, beginning on page 225, then
scanning Save . Default = 30,000 ms.
Presentation Mode
Note: Presentation Mode is not supported by the Orbit 7120plus scanner.
Presentation Mode uses laser or scanner illumination to detect bar codes. When in
Presentation Mode, the LEDs remain dim until a bar code is presented to the scan-
ner, then the LEDs turn up to read the code. If the light level in the room is not high
enough, Presentation Mode may not work properly.
Scan the following bar code to program your scanner for Presentation Mode.
User-Specified Good Read Delay
Read Time-Out
Presentation Mode