Honeywell HPM, Service

Page: 202 / 498

3 UCN Status Displays
3.4 Display Operation
202 HPM High-Performance Process Manager Service R688
Honeywell December 2020
UCN CABLE STATUS targets
The following table defines the functions of the UCN CABLE STATUS targets.
Table 29 UCN CABLE STATUS Target Selected
Target Function
TEST/SEL CABLE A Initiates a Backup Cable Test sequence for UCN cable A. If
no faults are detected, UCN cable A is activated for all UCN
devices. The command is executed by selecting the ENTER
target.
TEST/SEL CABLE B
Initiates a Backup Cable Test sequence for UCN cable B. If
no faults are detected, UCN cable B is activated for all UCN
devices. The command is executed by selecting the ENTER
target.
ENABLE SWAP Enables periodic swapping of the UCN cables. The
command is executed by selecting the ENTER target.
DISABLE SWAP
Disables periodic swapping of the UCN cables. The
command is executed by selecting the ENTER target.
ALL NODES Enables all UCN nodes to be affected by the cable function.
CANCEL Clears the BACKUP CABLE TST, TEST/SEL CABLE A,
TEST/SEL CABLE B, ENABLE SWAP, DISABLE SWAP,
UCN COMM STATUS, ALL NODES, and ENTER command
targets from the display.
ENTER The ENTER target must be selected for the chosen UCN
CABLE STATUS function to be executed.