Hog Technologies Stripe Hog SK2000, Operation Manual

Page: 67 / 166

67
Operation
Hog Head T-Handle Safety Pin Inserted In Articulation Hinge Hog Arm Safety Pin
A
B
Hog Head Articulation Hinge & Hog Arm Safety Pin Locations
A) Articulation Hinge Safety Pin / B) Hog Arm Safety Pin
9. Make sure the FLOAT switch is OFF.
10. Use the ARM UP/DOWN switch in the panel to
raise the arm and take the load off the safety
pin.
11. Use the WHEEL UP/DOWN switch to raise the
hydrostatic drive wheel to take the load off
safety pin.
12. Remove the Hog Arm safety pin and slowly
lower the arm until it is horizontal.
13. Lift the forward Hog Head caster wheel support
slightly to take the load off the articulation
hinge safety pin and remove the pin.
14. Slowly lower the arm and blasting head to the
full down position on the pavement.
15. Activate the FLOAT switch to engage Float
Mode.
16. Move the TANK/SEPARATOR toggle switch on
the driver side of the skid to SEPARATOR.
17. Plug the remote control switch into the recep-
tacle near the toggle switch.
18. Press the UP switch on the control to raise
the separator until it is in the vertical, full UP
position.