136
Scheduled Maintenance
WARNING
Step 10
Run the Thru-Shaft Motor Without Water
Pressure, Then Under Full Water Pressure.
Remove all tools and materials from the hog head
and raise it to the full up position.
Activate the hydraulic system and run the thru-
shaft motor at maximum RPM for 15 minutes.
Make sure not to apply water pressure dur-
ing this step.
Running motor without water pressure will fully
test the thru-shaft motor operation and allow the
bearings and seals to work themselves in. If the
spray bar does not turn initially, use a 2’ piece of
wood or a broom handle to rotate the spray head
counterclockwise to get it started. Figure 19.
If the thru-shaft motor is assembled properly, it
will start on its own each time it is activated from
this point forward. If it continues to stall on start
up, contact Hog Technologies Customer Service
for assistance.
Once the initial run up is complete and with the
spray head still turning at maximum RPM, make
sure all personnel are well clear of the spray head
and apply full water pressure. Run the thru-shaft
motor for another 15 minutes. Figure 20.
When testing is complete and with the unit still
running at maximum pressure, check the weep
hole in the thrust housing cap for water leakage. If
water is dripping from the hole, the swivel tit will
need to be changed. If no water is dripping from
the weep hole and the spray bar is still rotating at
maximum RPM, your unit is ready to be put back
into service. Figure 21.
Figure 19: Counterclockwise spray head rotation. Operate
1st 15 minutes at maximum rpm with no water
pressure.
Figure 20: Operate another 15 minutes at maximum rpm
and full water pressure.
Figure 21: Check for water dripping from weep holes just below the high pressure water hose connection.
INJURIES FROM ULTRA-HIGH PRESSURE WATER BLASTING
ARE vERY SERIOUS AND CAN RESULT IN A FATALITY OR
AMPUTATION. ALWAYS MAKE SURE ALL PERSONNEL
ARE A SAFE DISTANCE FROM THE WORK AREA BEFORE
THE PRESSURE PUMP IS ENGAGED. NEvER PUT HANDS,
FEET OR ANY PART OF YOUR BODY IN OR NEAR THE HIGH
PRESSURE STREAM.
Weep Hole
Summary of Contents for Stripe Hog SK2000
