Hog Technologies Stripe Hog SK2000, Operation Manual

Page: 135 / 166

135
Scheduled Maintenance
Step 8 (Cont)
Set the thrust housing cap on top of the thrust
housing and carefully press it into the housing.
Align the bolt holes in the cap to the threaded
holes in the thrust housing. Apply anti-seize to
the 3/8” Allen bolts and hand tighten using a
crisscross pattern. Use the 6 mm Allen wrench
to tighten the thrust housing cap bolts to “snug”
using a crisscross pattern. Figure 16.
1
2
3
4
5
6
Figure 16: Apply anti-seize to the thrust housing bolts and
tighten them in a crisscross pattern to snug
using a 6 mm Allen wrench.
Step 9
Install the High Pressure Water Hose and
Grease the Thru-Shaft Bearings.
Apply anti-seize to the threads on the top of the
thrust housing cap, flush the hose with low pres -
sure and install the high pressure water hose.
Hand tighten the swivel nut on the pressure hose.
Flush the thru-shaft using low pressure, then ap-
ply anti-seize to the threads on the shaft and on
the spray bar. Install the dirt shield, button seal
and spray bar on the thru-shaft.
Use a grease gun and apply grease to the thru-
shaft bearing until clean grease comes out of the
relief hole on the side of the thrust housing.
Figure 17: Apply anti-seize to the thrust housing threads
and install the high pressure water line.
Figure 18: Thru-shaft bearing grease fitting and grease
relief holes in thrust housing base.
Pressure Water Hose
Hand Nut
Grease Fitting
Relief Hole