Hog Technologies Stripe Hog SK2000, Operation Manual

Page: 57 / 166

57 57
Stripe Hog Systems
of the switch to raise the wheel, press and hold the
bottom of the switch to lower the wheel. Release
the switch to stop the wheel in that position.
FWD/REV
A momentary rocker switch that selects the truck
direction of travel by shifting the hydrostatic drive
system while the drive wheel is down and the hy-
draulic system is activated.
DUMP VALVE 40K
Controls the UHP dump valve (diverter valve).
When the switch is ON, the dump valve closes and
high water pressure from the UHP pump is directed
to the spray bar on the blasting head. When the
switch is OFF, the dump valve opens and the high
pressure water is diverted to the clean water tank.
Always make sure the truck is moving and the spray
bar is rotating before activating the dump valve.
Speed Dials And Digital Gauges
The speed dials are used to select the desired
RPM for the spray bar and the speed of the truck
hydrostatic drive.
HEAD ROTATION
The Head Rotation speed dial controls the speed
of the spray bar from 0 to maximum speed. Rotat-
ing the dial clockwise increases speed. Rotating it
counterclockwise reduces speed. Setting the Head
Rotation dial to 0 will stop the rotation of the spray
bar.
TRUCK SPEED
The Truck Speed dial controls the speed of the truck
while in work mode with the hydrostatic wheel
down. Rotating the dial clockwise increases speed
and rotating it counterclockwise reduces speed.
Setting the Truck Speed dial to 0 will stop the truck.
HIGH PRESSURE
A digital gauge that monitors the Ultra-High water
pressure to the blasting head.
CHARGE PRESSURE
A digital gauge that monitors the charge water
pressure at the UHP pump intake.
VACUUM PRESSURE
A digital gauge that monitors pressure in the
vacuum recovery system.
Skid Mounted Switches
These switches are mounted to the driver side of
the skid frame below the water tank.
TANK/SEPARATOR
A two position toggle switch that selects the mode
for the remote switch control. Move the switch
to the TANK position to use the switches on the
remote control to raise or lower the debris cage
to dump recovered debris. Move the switch to
the SEPARATOR position to use the switches on
the remote control to raise or lower the separator.
Speed Dials & Digital Gauges